As discussed before in Section
3.4.3↑, it is possible to have more than one configuration per check, provided that the ruleID is different for all configurations of the check. If a check that has configurable parameters is selected in the Configuration Editor, the
Clone button will be enabled. Clicking
Clone will clone the selected check and you can start editing this new configuration of the check. In Figure
4.3↑ a check with configurable parameters is selected and therefore the
Clone button is enabled. In case a check is configured more than once, it is possible to remove additional configurations. Clicking
Remove will remove the selected check configuration. The
Remove button is only present in case a check is selected that is configured more than once.